Radial hydraulic pump 0.7 liter 600 bar pressure

High pressure piston hydraulic pump with 3 small piston design has a capacity of 0.7 liters with a revolution of 1450 per minute and the maximum pressure allowed for this model of pumps is 600 bar permanent. The characteristic of these pumps is low noise and heats the oil less.
*You can refer to the products menu to view other pumps produced by this company that have various volumes.



shaft size

max drive power

RPM max


P max










PR 7

Operation guide
1. The hydraulic oil level should always be higher than the pump level.
2. Before connecting the pressure pipe to the system, start the pump for a few moments so that the air inside the pump is completely drained.
3. The pump shaft can rotate in two directions (left and right).
4. A suitable filter should be installed in the oil return circuit to the tank with a hole of 20 microns and cleaned every 500 working hours.
5. A suitable filter with a 125 micron hole should be installed at the head of the suction pipe inside the tank and cleaned every 500 working hours.
6. Install the air filter on the tank lid and clean it every 200 working hours.
7. The tank lid should be completely sealed to prevent the penetration of dust and pollution.
8. The inside diameter of the oil suction pipe should be one size larger than the diameter of the pump inlet.
9. If you see any kind of vibration and abnormal sound in the pump, stop working.
10. Type of oil: use hydraulic oil with an average temperature of 55 degrees.

بدون دیدگاه

Leave a Reply

Your email address will not be published. Required fields are marked *

خانهدرباره ماتماس با ما